Water and heat are often the culprits that cause white spots on wood furniture . When you place a glass or other wet item directly on wood , the moisture can get trapped under the finish , which causes the white appearance. Hot items such as a pizza box or hot pan placed on the wood can also cause white marks .
5 Ways to Remove Water Stains from Wood A hair dryer. Put your hair dryer on its lowest setting and direct it at the water ring. Mayonnaise or petroleum jelly. Apply a dab of either substance with a soft cloth and rub it into the mark in a circular motion. Toothpaste. Steel wool. Over-the-counter products.
Dear Kathy: A wood specialist suggests this: Mix equal parts nongel toothpaste and baking soda. Put the mixture on a slightly damp cloth and rub over the marks with the cloth, using moderate pressure. It may take up to 15 minutes to completely remove them.
Allowing mayonnaise or olive oil to sit overnight on milky spots usually removes them; oil seeps into the finish and replaces the water causing the milkiness. You can also get rid of milkiness in a lacquer finish by spraying lacquer thinner from a window spray bottle.
After having cleaned the table, the first method to try is to use a mixture of toothpaste and baking soda. Mix 1 tablespoon (approximately 20ml) of toothpaste with 2 tablespoons of baking soda (40ml) in a small bowl, creating a sticky white paste. Rub the paste into the heat mark in the direction of the wood grain.
Fortunately, there’s an easy, non-destructive method that might help you remove those water stains . Just cover the stain with a generous smear of mayonnaise . Let it sit anywhere from an hour to overnight. The mayonnaise won’t harm the wood , so if it doesn’t work, you’re only out some mayo .
Soak a clean , soft rag in mineral spirits. Wipe the cloudy area with the cloth, using long strokes that match the grain of the wood . The wax finish should start to look hazy and dull as it is being removed. Work in small sections if there is a large area of cloudiness to be removed.
6 Simple Ways To Remove Shoe Scuffs Baking Soda. This widely available product is likely sitting in your pantry or refrigerator right now. Nail Polish Remover . This bathroom cabinet staple is as effective at removing scuff marks as it is at removing nail polish. Rubber Eraser. Petroleum Jelly. Toothpaste.
A combo of baking soda and olive oil can help reduce and remove scratches from wood . Vacuum your floor thoroughly, then apply baking soda moistened with several drops of olive oil to marred areas. Wait five minutes, then buff in gently, using a soft sponge. Clean thoroughly with a damp cloth and dry with a towel.
All stains and finishes depend on evaporation to dry, but when the temperature is below 65 degrees or above 90 degrees, or the humidity level is above 50%, then the evaporation process is either too slow or too fast, causing your finish to either not dry or dry too quickly, turning white — like my deck!
When you apply lacquer , shellac or another quick- drying finish in humid conditions, the finish can turn milky because the moisture trapped in the finish didn’t have a chance to evaporate before the finish hardened. Polyurethane doesn’t exhibit the same behavior — not even the water-based type.
Solution – go over the affected area with 0000 steel wool and paint thinner to remove part of the stain . Be sure the stain is even (too light doesn’t matter right here) MAKE SURE THE STAIN IS EVEN – wipe off all excess until your rag comes off nearly clean. Then set it aside for 24 hours to completely dry.