French Polishing and Bespoke Furniture
Fill the Hole and Redrive the Screw Cut some thin strips or shavings from a piece of scrap wood from the same (or similar) species of wood . Dip the tips of strips into wood glue and tap them lightly into the hole with a hammer until the hole is filled. Let the glue dry for a few hours.
Things You ‘ll Need If you plan to paint the wood , you can cover them with wood filler . Both involve using a wood dowel plug. In total, three processes are covered that will allow you to discreetly cover a screw hole in just about any wooden surface.
Mortise-and-tenon joints can be cut by hand, using chisels, but most modern woodworkers employ a band saw or a tenoning jig on a table saw to safely form the tenon peg. The mortise is usually cut using a dedicated mortiser—a drill bit encased inside a four-sided chisel.
Insert the screw into the anchor and slowly screw it in. If using a threaded drywall anchor, screw it in using a Phillips head screwdriver. If using a toggle anchor, thread the toggle on the screw about 1/4 inch from the end. Push the toggle through the hole in the wall.
Fill the hole with any liquid glue that can be used on wood (like Elmer’s). Jam in several wood toothpicks until they’re very snug and entirely fill the hole . Allow to dry completely, then snap off toothpick ends so they’re flush with surface. Drive your screw through the repaired hole !
Top 5 Wood Fillers Minwax 21600000 High-Performance Wood Filler. Bondo 20082, Quart Home Solutions Wood Filler. FamoWood 40022126 Latex Wood Filler . Elmer’s E855 Carpenter’s Wood Filler. DAP 00585 Latex 6oz, White All Purpose Wood Filler.
Wood filler differs from wood putty in that the filler usually consists of sawdust or wood fibers suspended in a binder, while putty is usually a plastic such as epoxy, fiberglass or polyurethane. Moreover, unlike filler , putty doesn’t harden. Wood filler isn’t weatherproof and won’t last outdoors.
You’ll need some spackling paste, a putty knife and some sandpaper. Squeeze a small glob of the spackle into each hole , then use the putty knife to spread and blend it over the hole and wall. Once the spackle is dry, use the sandpaper to lightly sand the area, especially around the edges, to leave a smooth, flat wall.