Stripping is Faster and Often Safer. It’s almost always better to strip than to sand . To begin with, except in cases where the old finish is flaking off, it’s a lot more work to sand than to strip using a paint-and-varnish remover.
Strip and Refinish Furniture Step 1: Choose a Work Area. Work in a well-ventilated area such as your open garage or on an outdoor deck or patio. Step 2: Strip Away Old Finish . Wood begins to turn dark, dull and lifeless when it ages. Step 3: Sand It. Step 4: Apply Sanding Sealer. Step 5: Stain It. Step 6: Apply Sealant.
Laquer. You don’t need to remove all of the old stain to apply darker stain . But you do need to remove all of the lacquer, varnish or anything that will prevent new stain from absorbing into the wood . Your sanding block will initially glide over the old lacquer before it begins to cut into it and remove it.
The best paint stripper Best Overall: Citri-Strip Paint and Varnish Stripping Gel. Most Eco Friendly: Dumond Smart Strip Advanced Paint Remover. Fastest Working: Sunnyside 2-Minute Advanced Paint Remover. Most Family Friendly: MAX Strip Paint & Varnish Stripper. Most Heavy Duty: Dumond Peel Away 1 Heavy-Duty Paint Remover.
Wait about 30 minutes and test a small area to determine if the finish has loosened. If not, wait longer, even several hours if needed. You may need to reapply a coat if the stripper dries out before the finish has softened.
To remove those last bits of finish , palm sand with medium sandpaper (150 grit) until you see the bare wood . Then switch to fine sandpaper (200+ grit) until the entire piece is uniform. Wipe down the whole surface with a tack cloth to remove any dust from sanding.
Here is the process: Using a chip brush and working in sections, brush on the Klean Strip Stripper relatively thickly. Scrape off the stripper and finish using a plastic scraping tool. Rinse off the surface with lacquer thinner, rubbing with steel wool. Allow to dry, and you’re done!
Here are 5 Ways To Paint Furniture Without Sanding : USE A MINERAL PAINT. Mineral paint is very similar to chalk style paints in that no prep or prime is required. USE MILK PAINT + BONDING AGENT. As I already mentioned, the antique desk in this post was not prep- sanded . USE A BONDING PRIMER. USE A LIQUID SANDER /DEGLOSSER.
Removing wood stain can be an involved process since it absorbs into the grain of the wood . So, technically you must first use the chemical stripper to clear away the varnish (and some of the stain will lift, too), then sand away a thin layer from the surface of the wood to remove most of the stain .
The grit numbe is generally printed on the back of each sheet. Medium and fine grades of sandpaper are generally used in refinishing furniture and antiques. Coarse grits (those under #100) damage a fine wood finish. Medium grits , such as #120 and #150, are useful for removing old finish or scratches.
Minwax® PolyShades® is an easy way to change the color of your currently stained or polyurethane finished wood. There’s no stripping or heavy sanding necessary to remove the old finish!
The layer of stain remover tends to swell or bubble up when ready for removal . Before the stain remover has dried, gently scrape the layer of stain and stripper residue from the wood surface with a plastic scraper or putty knife. Scrape directly into a trash can if possible.
Wood stain is designed to penetrate into the grain of the wood , not to remain on the surface. If you happen to spread it too thickly, or you forget to wipe off excess, the material that remains on the surface will become sticky.