Use a tack cloth or damp cloth to remove sanding dust. prev. apply stripping agent to furniture . prev. remove residue with old cut off paintbrush. prev. use hammer to give new wood distressed look. Apply the Stain. attach replacement pieces to furniture . Sand the Entire Piece. apply stain with lint free rag.
To remove those last bits of finish, palm sand with medium sandpaper (150 grit) until you see the bare wood . Then switch to fine sandpaper (200+ grit) until the entire piece is uniform. Wipe down the whole surface with a tack cloth to remove any dust from sanding.
Stripping is Faster and Often Safer. It’s almost always better to strip than to sand . To begin with, except in cases where the old finish is flaking off, it’s a lot more work to sand than to strip using a paint-and-varnish remover.
Minwax® PolyShades® is an easy way to change the color of your currently stained or polyurethane finished wood . There’s no stripping or heavy sanding necessary to remove the old finish!
Valuable Furniture Antique furniture will often diminish in value if they are refinished . Unless the finish is seriously damaged, you would be better off to leave it alone. And if it is significantly damaged, unless you are an experienced refinisher, this is a job best left to the pros.
The best paint stripper Best Overall: Citri-Strip Paint and Varnish Stripping Gel. Most Eco Friendly: Dumond Smart Strip Advanced Paint Remover. Fastest Working: Sunnyside 2-Minute Advanced Paint Remover. Most Family Friendly: MAX Strip Paint & Varnish Stripper. Most Heavy Duty: Dumond Peel Away 1 Heavy-Duty Paint Remover.
Strip and Refinish Furniture Step 1: Choose a Work Area. Work in a well-ventilated area such as your open garage or on an outdoor deck or patio. Step 2: Strip Away Old Finish. Wood begins to turn dark, dull and lifeless when it ages. Step 3: Sand It. Step 4: Apply Sanding Sealer. Step 5: Stain It. Step 6: Apply Sealant.
Wait about 30 minutes and test a small area to determine if the finish has loosened. If not, wait longer, even several hours if needed. You may need to reapply a coat if the stripper dries out before the finish has softened.
Typically when stripping furniture , after you’ve removed the old paint, stain, or varnish, your wood will still be slightly stained. Sanding helps to remove that residual staining, but you may not be able to sand it down to a perfectly raw wood finish. Use a tack cloth to remove the leftover sanding grit.
Failing to Strip Completely Leaving spots will yield an uneven surface when you finally start finishing it. Apply enough stripper to keep the surface wet, and never work in direct sunlight as you can dry the wood . Remove the finish completely before sanding to get the surface ready for the new finish.
To remove it, dampen a soft, fine-grade steel-wool pad with more paint stripper and rub it against the wood , following the wood grain, then wipe off the softened stain with a rag. If the stripper requires rinsing, use the method the manufacturer recommends.
This task is accomplished through the use of chemical paint and varnish removers and light sanding. Assemble equipment. Apply stripper using a brush. Scrape the area with a plastic scraper or plastic putty knife. Brush stripper onto an area adjacent to the area previously stripped.
11 ways we know to remove paint from wood without chemicals : Sanding. Pressure washer. Vinegar. Baking soda. Wire brush. Heat gun. Paint stripers. Infrared devices.